The SPC Procedure

The IRCHART statement produces control charts for individual measurements and moving ranges. Table 4 lists the options that you can specify in an IRCHART statement. For detailed descriptions of these options, see the section Dictionary of Options.

Table 4: IRCHART Statement Options

Option	Description
CIINDICES	Computes capability index confidence limits
EXCHART	Produces results only for charts in which exceptions occur
NO3SIGMACHECK	Enables tests for special causes to be applied when control limits other than limits are in effect
NOPRINT	Suppresses ODS output
OUTLIMITS=	Creates an output data table that contains control limits
OUTTABLE=	Creates an output data table that contains subgroup summary statistics and control limits
SIGMAS=	Specifies the width of the control limits in terms of a multiple of the standard error of the subgroup summary statistic
SMETHOD=	Specifies the method of estimating the process standard deviation
SPECS=	Specifies an input data table that contains process specification limits and computes process capability indices
TEST2RUN=	Specifies the length of the pattern for Test 2
TEST3RUN=	Specifies the length of the pattern for Test 3
TESTNSTD	Applies tests for special causes to standardized chart statistics
TESTOVERLAP	Performs tests for special causes on overlapping patterns of points
TESTS=	Requests tests for special causes for the individual measurements chart